Restore Proper Screen Protector Cutting in Three Stages

If the machine cannot cut screen protector materials properly, first replace both the blade and blade holder with new ones. Then set the cutting pressure to 300 and attempt the cut again. Fine-tune the cutting module only if the problem remains after completing those two actions. The adjustment is intended to restore proper cutting operation when replacing the cutting components and changing the pressure have not resolved the issue.

When This Procedure Applies

Use this procedure when the machine is unable to cut screen protector materials properly. It follows a staged approach: begin by replacing the cutting components, retry at the documented pressure setting, and proceed to cutting-module adjustment only when the earlier actions do not correct the problem.

The cutting-module adjustment is therefore not the first action. Whether it is necessary depends on the result after installing the new blade and blade holder and attempting another cut with the cutting pressure set to 300.

Supported Cutting-Issue Procedure

1. Replace the blade and blade holder. Remove the existing blade and blade holder from use and replace both with new ones. The documented procedure requires replacing both components before changing the cutting-module adjustment.

2. Set the cutting pressure to 300 and retry. After replacing the blade and blade holder, set the machine’s cutting pressure to 300. Attempt to cut the screen protector material again so that the result can determine whether any further adjustment is needed.

3. Fine-tune the cutting module if the issue persists. Proceed to fine-tuning only if the machine still cannot cut the screen protector material properly after the component replacement and the cutting attempt at pressure 300. The supplied guidance identifies cutting-module fine-tuning as the next action for restoring proper operation, but it does not document the individual fine-tuning steps in text.

Completion Check and Limitation

After each documented change, use the next cutting attempt to determine whether the machine is operating properly. If replacing the blade and blade holder and setting the cutting pressure to 300 resolves the problem, no cutting-module fine-tuning is indicated.

If the problem continues, the documented next stage is to fine-tune the cutting module. The available written instructions do not provide specific adjustment values, directions, or additional checks for that stage, so those details should not be inferred. Completion is reached when the machine is again able to cut the screen protector material properly.